Yamaha A3000 Owner's Manual page 137

AsgnPut
Knob 4
• Selects the assignable-output destination for the A/D-input signal.
• Set this value to off if you do not want to output the signal to any assignable output.
Set the value to ASL&R if you want to output the signal to the A3000's standard
assignable-output pair. The other settings are meaningful only if you have installed
the optional I/O expansion board (AIEB1 board); if the board is not installed, these
settings are equivalent to off.
• If you have installed the AIEB1 board, you may also select from among the other
assignable-output pairs indicated above. If you select DIG&OUT, the A3000 will out-
put the identical signal to both the DIGITAL and the OPTICAL output jacks.
AsLevel
Knob 5
Sets the output level at the assignable outputs.
off, ASL&R, AS1&2, AS3&4, AS5&6, DIG&OPT
= 0,...,127
SETUP Function
Chapter 4 PLAY Mode
135