Yamaha A3000 Owner's Manual page 329

Now support the hard disk in the correct position with one hand (on the inside of the
unit) while using the other hand to insert the screws and fasten into place. Note that the
screws must be inserted from the outside of the unit, through the base (see drawing)
The hard disk is now fully installed. There is no need to remove the disk when installing
other devices.
Gently lower the A3000 back down into its normal position. Then replace the
10.
top cover and fasten it in place with the screws removed at Step 4 above.
• When remounting the cover, be careful to keep clear of internal cabling, and do not
allow cables to be pinched or pulled.
• When refastening the three screws on the top, press inward on the top center part of
the front panel.
Plug in the power cord.
11.
Important
After installing the hard disk, connect your audio and MIDI devices, and turn on the
A3000. Then mount the hard disk ( 270), format it ( 254), and partition it into vol-
umes ( 266).
Installing an Internal Hard Disk
Appendix
327