Sequence - Play&Rec (Playback And Recording) - Yamaha A3000 Owner's Manual

SEQUENCE - Play&Rec (Playback and Recording)
Plays or records a sequence.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Use this page to play or record (or over-record) the sequence that you select at the
SeqSel page ( 296).
Knob 1 Change Page
• Turn the knob to switch between the function's SeqSel and Play&Rec pages.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Speed(%)
Knob 2
• This value sets the playback speed, relative to the recorded speed.
• The setting is by percentage. A value of +0 reproduces the original speed; a setting of
• If you are playing back an imported SMF (standard MIDI file), the available range
Knob 4
• Push the knob to begin recording.
• Once recording has started, you can pause it by pushing Knob 4 (>PAUSE), and then
Knob 5
• Push the knob to begin playback.
• Once playback has started, you can pause it by pushing Knob 4 (>PAUSE), and then
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
= -50,...,+50
+50 increases the speed by a factor of 1.5, while a setting of -50 cuts the speed in
half.
may be less than shown here.
resume from the point you left of by pushing Knob 4 (>CONTINUE) once again. You
can terminate the recording at any time by pushing Knob 5 (>STOP).
resume from the point you left of by pushing Knob 4 (>CONTINUE) again. You can
terminate playback at any time by pushing Knob 5 (>STOP).
SEQUENCE Function
Turn Knob 1 to select Play&Rec.
Knob 3 Knob 4
- -
-
Select P/S
>REC
>PLAY
Chapter 8
Knob 5
-
UTILITY Mode
297