Fade - Yamaha A3000 Owner's Manual

FADE

Sets a fade-in or fade-out for the sample.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
This command selects whether the sample "fades in" or "fades out," and sets the length
and type of the fade. Note that fade-in always starts at the start address, while fade-out
always ends at the end address. (For information on how to edit the start and end ad-
dresses, see page 164.) The following drawing illustrates the concept.
Important
This command does not operate on sample banks.
Knob 1 Change Page
• Turn the knob to change to a different command page.
• Push the knob to execute processing. The A3000 returns a confirmation screen. Push
In/Out
Knob 2
Turn the knob to select whether the sample uses fade-in or fade-out.
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
Length
Start address
Length
End address
Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
= in, out
Press the COMMAND key, then turn Knob 1 to select >FADE.
Knob 3 Knob 4
- -
Fade In
Fadeout
>FADE
Chapter 5
COMMAND Pages
Knob 5
-
EDIT Mode
155