Sample Function; Sample - Smpload (Load Sample(S)) - Yamaha A3000 Owner's Manual

You use the SAMPLE function to load one or all samples from a floppy disk or SCSI disk
volume into the A3000 main memory. Before using this function, you must select the
source disk or volume using the DISK or VOLUME function.
• If loading from a floppy disk, you must first insert the floppy disk into the A3000
• If loading from a SCSI disk, you must first select the disk (partition) and volume
For details about the relationship between disks, partitions, and volumes, refer to the
section entitled "Disks and Volumes" in Chapter 3. ( 81)
Please note that is possible to audition a sample directly from SCSI disk, so that you can
check the sound before deciding whether or not to load it. To hear the sample, first
select it with Knob 2 or 3 at the SmpLoad page (see below), and then press the AUDI-
TION key. (This feature does not work with floppy disks, and some SCSI disks may not
support it.)
FYI
Before you can load samples, you must first save them to disk. You can save your sam-
ples to disk using the PLAY | SAMPLE function. ( 112)

SAMPLE - SmpLoad (Load Sample(s))

Loads one or all samples from disk.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Use this page to load one or all samples from disk.

SAMPLE Function

floppy drive, and then select the disk at the DISK function. ( 268)
containing the program(s) you want to load. ( 268, 266)
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
-
SAMPLE Function
Knob 3 Knob 4
-
-
Chapter 7
Knob 5
-
DISK Mode
261