Yamaha A3000 Owner's Manual page 175

VelXfd
Knob 4
• Set this parameter on to enable velocity crossfade, or off to disable.
• If you set the value to off, the sample plays out over the selected velocity range only.
Velocities outside of the range do not produce any sound from the sample.
• If you set the value to on, velocity values close to but outside of the specified range
will also produce the sample, with the sample's output level decreasing with increas-
ing distance from the range limit.
• The use of velocity crossfade allows you to blend samples that are set for playback at
different velocity ranges, so that sound does not change drastically in response to
slight velocity changes near the range limit.
If Velocity Crossfade = OFF:
Sound Level
If Velocity Crossfade = ON:
Sound Level
VelSense
Knob 5
• This value sets the sample's velocity sensitivity. The velocity sensitivity determines
how the sample's output level varies in response to changes in velocity.
A value of 0 produces constant output level for all velocities within the velocity range.
Positive values causes output level to increase with increasing velocity, while nega-
tive settings have the opposite effect.
• You can use the UTILITY | MIDI Adjust page to set the adjustment that the A3000
applies to received velocity values before transmitting them to the internal tone gen-
erator. ( 307)
= off, on
Low
Low
Start = -63,...,+63
MAP/OUT Function
Velocity
High
Velocity
High
Chapter 5 EDIT Mode
173