Setup Function; Setup - Recdata - Yamaha A3000 Owner's Manual

You use the SETUP function to set up for a recording — to select the input source, to set
the recording start and stop methods, and to set a wide variety of other setup param-
eters.

SETUP - RecData

Sets basic recording parameters.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
You use this page to designate the input source, to select the sample type (monaural or
stereo), and to set the sampling frequency and the pretrigger time.
Knob 1 Change Page
• Turn the knob to change to a different page within the SETUP function. Available
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Input
Knob 2
This setting selects the input source for the recording. Note that the DIGITAL and
OPTICAL settings are effective only if you have installed the optional I/O expansion
board (AIEB1 board).
AD L
AD L/R
STOut

SETUP Function

EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
pages are: RecData (this page), Target, KeyRnge, Trigger, and Process.
= AD L, AD L/R, STOut, DIGITAL, OPTICAL
Record analog signal from the front panel's INPUT-L jack.
Record analog signal from both front-panel input jacks (INPUT-
L and INPUT-R).
Record the signal that the A3000 is producing and transmitting
to its own stereo outputs. (A process called resampling: the A3000
re-records its own signal. You use this setting to record playback
that you control from a MIDI keyboard or other such device.)
SETUP Function
Turn Knob 1 to select RecData.
Knob 3 Knob 4
- -
Select P/S
Chapter 6
Knob 5
-
RECORDING Mode
227