Yamaha A3000 Owner's Manual page 58

Sample Editing
Using the LFO
Chapter 2 Trying It Out
56
We will now set the LFO (low-frequency oscillator) to create a vibrato in the ahhhh
sample.
Procedure
1. Select EDIT mode, LFO function.
PLAY
PROGRAM
EDIT
TRIM / LOOP
RECORD
REC
PROGRAM
DISK
TOTAL EQ
UTILITY
Press Knob 1, and then turn Knob 2 or Knob 3 to select the Voice AH sample
2.
for editing. Then press Knob 1 again.
Turn Knob 1 to select the PtchMod (pitch modulation) screen. Then turn
3.
Knob 2 to set the Depth to 30.
The screen now looks like this.
Turn Knob 1 to select the Common screen. Turn Knob 2 to set Wave to
4.
Triangl. Turn Knob 3 to set Speed to 15; turn Knob 4 to set Delay to 90.
Now play and hold a key between C2 and B2 at your keyboard.
5.
Notice how a gentle vibrato (pitch waver) begins after the sound has been held for a few
moments.
In the next section we will begin to do some program editing.
If you wish to stop here for a while and switch off the power, please save your edited data
to floppy disk ( 64 to 66). When you are ready to resume operation, please reload the
data from the disk ( 67) and then proceed to the next page.
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI