Loopxfd (Loop Crossfade) - Yamaha A3000 Owner's Manual

COMMAND Pages

LOOPXFD (Loop Crossfade)

Sets up the loop crossfade for the sample.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2:
Knob 3
Chapter 5 EDIT Mode
158
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
This command sets up a loop crossfade (overlapping fade-in and fade-out) so as to pro-
duce a smoother loop
Important
This command does not operate on sample banks.
Change Page
• Turn the knob to change to a different command page.
• Push the knob to register the crossfade. The A3000 returns a confirmation screen.
Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
Width
Sets the length of the crossfade area, as a percentage of the total loop length.
Area
Selects the area over which crossfade is applied, and determines the segments that are
used to generate the crossfade. (See the illustrations on the next page.)
sustain
release
CONTROL
MIDI / CTRL
Press the COMMAND key, then turn Knob 1 to select >LOOPXFD.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= 0%,...,100%
= sustain, release
Generates the crossfade by merging the end part of the loop with
the area just preceding the loop start. This method produces
smoother sustained looping, and the crossfade recurs with each
iteration.
Generates the crossfade by merging the initial part of the loop
with the initial segment following the loop area. This method
produces a smoother loop release, and the crossfade occurs only
once (as the loop is exited). This method is useful only with the
"– – " loop type ( 169).
Knob 4 Knob 5
- -
- -
>LOOPXFD