8
Connect to the base radios transceiver module in CSS through an Ethernet connection. See
Through an Ethernet Port Link, page
9
Select Service → Test and Measurement Screen from the menu.
Figure 5-29 CSS Test and Measurement Screen
10 Set up the CSS Test and Measurement screen to display received BER through Configuration/Service Software
(CSS), as follows:
a. Click Change to Service Mode. This keys up the base radio in service mode.
b. Re-open the Test and Measurement Screen.
c. Select a pattern that matches the Modulation Type selection for the RF Control Settings in the service
monitor.
To match the QPSK Modulation Type on the service monitor screen, select the 4 QAM pattern in
CSS.
d. Click Start Pattern Transmission.
e. Click Start BER Measurement.
6871022P86-A - November 2012
4-11.
5.11.4 Measuring HPD BR Rx Sensitivity and Rx BER
4.4.4 Connecting
5-55