Motorola GTR 8000 Manual page 252

GTR 8000 Base Radio
24 Restore the following Clear Protocols parameters in the Remote Access Configuration tab on the Device
Security Configuration screen in CSS. See "Device Security Configuration Remote Access/Login Banner
(Ethernet)" in the CSS Online Help.
25 Update/Verify the DNS, Syslog, and RADIUS Service Configuration. See Chapter 7 of the Authentication
Services manual.
26 Set the NTP Server Settings. See "NTP Server Settings" in the CSS Online Help.
27 Open the Software Download application.
Make sure to load the correct version of the software. There is a possibility of a mismatch in software
versions when replacing the transceiver module with an on-hand spare. If a mismatch in software
versions occurs, this may cause the transceiver to go into a configuration mode of operation with
a reason of 'Invalid Software Version'. To exit the base radio out of configuration mode, see CSS
Procedures > Changing from Configuration to Normal Mode in the CSS Online Help.
28 Transfer and install the latest base radio software using Software Download as follows:
a. Select File → File Manager from the menu.
Step result: The Software Depot File Manager opens.
b. Select Component Operations → Import Fileset from the menu.
Step result: The Import a Fileset Into the Software Depot dialog box appears.
c. Click Browse and search for the swdlv3.cfg file on the CD. Click Open.
d. Click Generate to add the file to the Components In the Software Depot list. Click OK.
e. Exit the Software Depot File Manager.
f. From Software Download, select the appropriate ASTRO 25 system Site Type, and the relevant zone
and site information, and if applicable, the Subsite. The Subsite ID is only available when the Site ID
is between 1-64.
g. Select Single Device Mode.
h. Enter the <IP address> of the device. Click Continue.
i. In the Select an option window, select Upgrade Software Application. Click Continue.
j. Select either Site Repeater, HPD Base Radio, Multisite Base Radio, or Conventional Base Radio for
the Application Type.
k. Select Transfer and Install for the Operation Type.
l. For Software Component, select a configuration fileset from the drop-down list. If the desired configuration
fileset needs to be imported, perform substeps 1 through 5.
m. Select Start Operation.
Step result: The software is transferred and installed on to the device. This takes several minutes to complete.
When completed, the two progress bars on the Transfer and Install window display 100% and a completion
message displays in the Transfer message box.
9-8 6871022P86-A - November 2012