Site-Specific Information; Gtr 8000 Base Radio Hardware Installation; Placement And Spacing - Motorola GTR 8000 Manual

GTR 8000 Base Radio

3.3.13.1 Site-Specific Information

When systems are staged by the Motorola Center for Customer Solution Integration (CCSI), site-specific system
documentation is created to document how the system was staged. The Field Engineer assigned to the system creates
all of the site-specific information including the following:
• Site design drawings showing the location of racks, cabinets, cable trays, and other components
• Rack drawings showing the location of the equipment in each rack
• Cable matrix in a table format that shows each cable and its connections
• Interconnect wiring diagrams to show the cable connections between devices
• Pre-programmed parameters of each site component
• Templates used to program each device
• All firmware and software revisions of each site component
• Test data from each device that requires operational verification
• Optimization requirements and settings of each electrical path
• Acceptance Test Plan for the site components
This site-specific information must be maintained to reflect the current site configuration and
layout for the system.

3.4 GTR 8000 Base Radio Hardware Installation

The following is information specific to GTR 8000 Base Radios.

3.4.1 Placement and Spacing

Cabinet and racks allow equipment to be added to a site. Always consider room for expansion when setting up a site.
Cabinets or racks my be installed adjacent to each other or to other equipment. However, all cabinets and racks
must have sufficient floor space to permit access for installation and service.
Recommended clearance for service and installation is at least 2 feet in the front and rear.
Front access:
• At least 2 feet floor access in front of the cabinet or rack.
Side and rear access:
• At least 2 feet floor access at the rear of the cabinet or rack, or
• At least 2 feet access on at least one side of the cabinet or rack, plus 6 inches at the rear of the cabinet or rack.
To maintain this clearance, the following is recommended:
• If there will be less than 2 feet rear access, do not install more than 2 cabinets or racks side by side, and
allow at least 2 feet access on at least one side of each cabinet or rack.
• For the cabinet version, if there will be less than 2 feet rear access, do not install the optional rear door on
the cabinet.
3-16 6871022P86-A - November 2012