Figure B-3 Analog Simulcast Assembly In Rack - Gtr 8000 Base Radio Backplane; Figure B-4 Connected Analog Simulcast Cable - Gtr 8000 Base Radio Front View - Motorola GTR 8000 Manual

GTR 8000 Base Radio
3 Secure the assembled Analog Simulcast panel (using the inner hole patterns) to the extender brackets using
four M4 (item G) screws using a Tx20 bit driver. Torque to 17 in-lbs.
Figure B-3 Analog Simulcast Assembly in Rack – GTR 8000 Base Radio Backplane
Connect an approved ground cable to the ground lug on the Analog Simulcast panel using an M6 (item I) star
4
screw using a Tx30 bit driver. Torque to 55 in-lbs.
5 Remove the fan module to gain access to the Transceiver Option Card (TOC) on the transceiver module.
Replacing the Fan Assembly, page 9-10
6 Route the Analog Simulcast Cable over the GTR 8000 Base Radio if the panel was mounted over the base radio.
Figure B-4 Connected Analog Simulcast Cable – GTR 8000 Base Radio Front View
Connect the 50 pin connector to the system connector on the TOC.
7
8 Connect the RJ45 wireline connector to the wireline port on the TOC.
Replace the fan module on the base radio so that the Analog Simulcast Cable hangs out through the right-side
9
of the fan module.
10 Secure the remaining Analog Simulcast Cable to the rack using cable ties.
B-4
for details.
9.3
6871022P86-A - November 2012