Motorola GTR 8000 Manual page 251

11 Using the handle, gently pull the transceiver module straight out, along the guides on which it sits.
12 Slide in the replacement transceiver module along the guiding rails until it is engaged. A slight push may be
needed to engage the module.
If the transceiver module stops well before it is engaged, it is in an incorrect position. Either it is in the
wrong slot or it is rotated 180°. The module has a keying feature that prevents it from going all the way
into an incorrect slot, or going into the correct slot but rotated 180. Do not try to force the module.
Step result: LEDs on the transceiver turn on when it is engaged.
13 Secure the transceiver module to the chassis with the two captive screws on the front of the module.
14 Reconnect all cables to the ports on the transceiver.
15 Reinstall the fan assembly. See
If you chose to turn off the power, set the rocker switch on the front of the associated power supply
to the On (1) position.
16 Connect to the devices DB-9 serial service port using Configuration/Service Software (CSS). See
Connecting Through a Serial Port Link, page
17 Set the IP Address and BR_CM Pairing Number for the device. See
Pairing Number Using CSS, page
18 Set the Serial Security Services Using CSS. See
page 4-9.
19 Disconnect the laptop PC from the transceivers DB-9 serial port.
20 Connect to the device modules Ethernet service port using Configuration/Service Software (CSS). See
Connecting Through an Ethernet Port Link, page
21 Reconfigure the SNMPv3 user credentials. See
Using CSS, page
22 Set the SWDL transfer mode. See
23 Reconfigure for SSH. See Chapter 4, "Configuring SSH for RF Site Devices and VPMs Using CSS" in the
Securing Protocols with SSH manual or see "Device Security Configuration Remote Access/Login Banner
(Ethernet)" in the CSS Online Help.
6871022P86-A - November 2012
9.3 Replacing the Fan Assembly, page
4-7.
4-15.
4.4.5.6 Setting the SWDL Transfer Mode Using CSS, page
9-10.
4-4.
4.4.3.1 Setting the Device IP Address and
4.4.3.3.1 Setting the Serial Security Services Using CSS,
4-11.
4.4.5.3 Changing SNMPv3 Configuration and User Credentials
9.2.1 How To Replace a Transceiver Module
4-23.
4.4.2
4.4.4
9-7