Table of Contents
Advertisement
When the IP addresses exceeds the total, removing IP addresses allows the UEM to be identified as the
current manager and can handle traps for the device.
4.4.5.8 Setting Up the Local Password Configuration Using the CSS
When and where to use:
This procedure describes how to set the complexity requirements and controls for the local service account
password. The updated password criteria is enforced on the next password change for the device's local service
account. Password Configuration is an optional feature. For information, see "Password Configuration" in the
CSS Online Help.
Procedure Steps
1
Connect to the device using Configuration/Service Software (CSS) through an Ethernet port link. See
Connecting Through an Ethernet Port Link, page
2
In the navigation pane, click the Password Configuration element.
Step result: The Password Configuration window appears.
Figure 4-7 Password Configuration Window
Complete the following fields:
3
• Minimum Password Length—This field allows you to enter a value as the minimum length for the
Password. The minimum can be between 8 and 255 characters, with a default of 10 characters.
• Number of Required Special Characters—This field allows you to enter a value for the required
number of special characters which must be included in the Password. The value can be between 0
and 255, with a default of 1.
• Number of Required Numeric Characters—This field allows you to enter a value for the required
number of numeric characters which must be included in the Password. The value can be between 0
and 255, with a default of 2.
• Number of Required Uppercase Characters—This field allows you to enter a value for the required
number of uppercase alphabetic characters which must be included in the Password. The value can be
between 0 and 255, with a default of 2.
6871022P86-A - November 2012
4.4.5.8 Setting Up the Local Password Configuration Using the CSS
4-11.
4.4.4
4-25
Advertisement
Table of Contents
Troubleshooting
