If the antenna relay is Enabled and it is then disconnected, a failure is generated and logged stating the
antenna relay is disconnected. However, the base radio also generates an exciter failure because the
antenna relay is controlled and monitored through the exciter module. The exciter failure should be ignored
until after the antenna relay failure is corrected. The failures are reported in the Status Report and UEM.
Figure 2-21 Antenna Relay Module Connections
2.3.11.1 Mounting Locations
The antenna relay module may be installed in either of two locations.
On base radios not equipped with the peripheral tray, the antenna relay is mounted on the backplane cover.
6871022P86-A - November 2012
2.3.11.1 Mounting Locations
2-19