Configuration Of The Ifr 2968 Manual Test Screen - Motorola MTM800 User Manual

6 - 8

Configuration of the IFR 2968 Manual Test Screen

The setup depends on the firmware version of the IFR 2968, the firmware version of the
terminal and the customer programming of the terminal. The following procedure is only
an example.
1. To enter "Manual test" screen, press the "Manual" soft key.
2. Press the "Control Channel" soft key. Thereafter, enter the control channel Number
3. Press the "Traffic Channel" soft key. Enter "2440" for 450-470MHz and press the
4. Press the "RF Gen Level" soft key. Thereafter, enter "-90" and press "dBm" data keys
5. Press the "Mobile Power" soft key, enter "35 dBm/3.2W", using soft key.
6. Press the "Burst Type" soft key and "Normal" soft key.
7. This completes the Manual test equipment configuration setup.
and press the "Control Channel" soft key. The control channel Number is
"2440" = Rx 461.0125MHz.
"Traffic Channel" soft key. The marker goes to Timeslot. Enter "3" and press the
"Traffic Channel" soft key. (Note that the Traffic Channel number changes automati-
cally after entering the Control Channel number).
followed by "RF Gen Level" soft key.
Note: The System Setup Configuration Data is saved even after the power is turned
off. However, the Manual Test Setup is not saved.
TEST SETUP & TESTING