Configuring The T1-2R With Talk-Around Option Kit - Motorola GTR 8000 Manual

GTR 8000 Base Radio
2 If the base radio and receiver are powered up, ensure that each device is switched to service mode or powered
down, as follows:
If you choose to turn off the power, set the rocker switch on the front of the associated power supply to
the Off (0) position and skip this step.
a. Connect to the base radio's transceiver module Ethernet service port using Configuration/Service Software
(CSS). See
b. Select File → Read Configuration From Device from the menu.
c. Select Service → Test and Measurement Screen from the menu.
d. Click Change to Service Mode.
e. Disconnect the Ethernet cable from the base radio's transceiver module Ethernet service port.
f. Repeat for each device in the configuration.
Attach the antenna relay to the backplane of the GTR 8000 Base Radio. See
3
page 2-18 and
4 Remove the fan module to gain access to the Transceiver Option Card (TOC) on the transceiver module. See
9.3 Replacing the Fan Assembly, page 9-10
5 Connect cables to each device according to
Replace the fan modules for the base radio and receivers.
6
If you chose to turn off the power, set the rocker switch on the front of the associated power supply
to the On (1) position.
7 If the base radio and receivers are in service mode, switch each device to normal mode, as follows:
a. Connect to the base radio's transceiver module Ethernet service port using Configuration/Service Software
(CSS). See
b. Select File → Read Configuration From Device from the menu.
c. Select Service → Test and Measurement Screen from the menu.
d. Click Change to Normal Mode.
e. Disconnect the Ethernet cable from the base radio's transceiver module Ethernet service port.
f. Repeat for each device in the configuration.
A.2.4 Configuring the T1-2R with Talk-Around Option Kit
Prerequisites:
Ensure that all required installation procedure have been performed for the base radio and receiver(s) and that the
devices have been powered up.
A-20
4.4.4 Connecting Through an Ethernet Port Link, page
9.14 Replacing an Antenna Relay, page 9-40
4.4.4 Connecting Through an Ethernet Port Link, page
for details.
for details.
Figure A-8 T1-2R Talk-Around Option Kit Wiring
4-11.
2.3.11 Antenna Relay Module,
Diagram.
4-11.
6871022P86-A - November 2012