Transceiver Services-Controlled Leds; Table 10-3 Transceiver Application-Controlled Leds; Table 10-4 Transceiver Services-Controlled Leds - Motorola GTR 8000 Manual

Table 10-3 Transceiver Application-Controlled LEDs

Condition
Booting Up*
Lamp Test
Receiver Inhibited
Receiver Active
RF Channel Interference
Monitor Before Data Transmit
Illegal Carrier
Control Channel (Operating)
Control Channel (Failsoft)
Service Mode
Transmitter Inhibited
Infrastructure Link Connected
(V.24, IP, and 4–wire/V.24)
Partial Infrastructure Link
Established (V.24 link
established, 4–wire link not
established)
Infrastructure Link Disconnected
(V.24, IP, and 4–wire/V-24)
* During a normal boot up sequence, LEDs 1 through 4 blink from left to right and from right to
left continuously for several seconds.

10.1.1.4 Transceiver Services-Controlled LEDs

For the service-controlled LEDs, the color of all LEDs must be observed in order to interpret the condition of the
transceiver.

Table 10-4 Transceiver Services-Controlled LEDs

Condition
Lamp Test
Receiver Inhibited
6871022P86-A - November 2012
LED 2
LED 1 Control
Receive Channel
Status Status
Green Green
Amber Amber
Amber
(blinking)
Green
Red
(blinking)
Green
Red
(blinking)
Green
Green
(blinking)
LED 5 LED 6
SWDL/VLAN Fault
Amber
10.1.1.4 Transceiver Services-Controlled LEDs
LED 4
LED 3 Infrastructure
TX/Service Payload Link
status Status
Green
Amber
Amber
Amber
(blinking)
Green (blinking)
LED 7
Amber Amber
Red
Green
Amber
Green
Amber
10-3