Changing The Size Of The Paper In The Paper Tray - Xerox WORKCENTRE 3210 User Manual

MEDIA TYPE
Labels • To avoid damaging the machine, use only labels
designed for use in laser machines.
- When selecting labels, consider the following
factors:
- Adhesives: The adhesive material should be
stable at your machine's fusing temperature.
Check your machine's specification to view the
fusing temperature, see page 86.
- Arrangement: Only use labels with no exposed
backing between them. Labels can peel off sheets
that have spaces between the labels, causing
serious jams.
- Curl: Prior to printing, labels must lie flat with no
more than 13 mm of curl in any direction.
- Condition: Do not use labels with wrinkles,
bubbles, or other indications of separation.
• Make sure that there is no exposed adhesive
material between labels. Exposed areas can cause
labels to peel off during printing, which can cause
paper jams. Exposed adhesive can also cause
damage to machine components.
• Do not run a sheet of labels through the machine
more than once. The adhesive backing is designed
for only a single pass through the machine.
• Do not use labels that are separating from the
backing sheet or are wrinkled, bubbled, or otherwise
damaged.
Card stock or • Do not print on media smaller than 76 mm wide or
custom-sized 356 mm long.
materials • In the software application, set margins at least
6.4 mm away from the edges of the material.
Preprinted • Letterhead must be printed with heat-resistant ink
paper that will not melt, vaporize, or release hazardous
emissions when subjected to the printer's fusing
temperature for 0.1 second. Check your machine's
specification to view the fusing temperature, see
page 86.
• Letterhead ink must be non-flammable and should
not adversely affect printer rollers.
• Forms and letterhead should be sealed in a
moisture-proof wrapping to prevent changes during
storage.
• Before you load preprinted paper, such as forms
and letterhead, verify that the ink on the paper is
dry. During the fusing process, wet ink can come off
preprinted paper, reducing print quality.
36 _Loading originals and print media
GUIDELINES
CHANGING THE SIZE OF THE PAPER IN THE
PAPER TRAY
To load longer sizes of paper, such as Legal-sized paper, you need to
adjust the paper guides to extend the paper tray.
1. Press and hold the guide lock, and slide the paper length guide to locate
it in the correct paper size slot. It is preset to Letter or A4 size depending
on the country.
2. After inserting paper into the tray, adjust the support guide so that it
lightly touches the paper stack.
3. Squeeze the paper width guides, as shown and slide them to the stack
of paper until it lightly touches the side of the stack.
4. Load the paper into the tray.
1 Paper length guide
2 Support guide
3 Guide lock
4 Paper width guides