Xerox WORKCENTRE 3210 User Manual page 75

MESSAGE MEANING
Memory Full The memory is full.
Not Assigned The speed button or
speed dial number
you tried to use has
no number assigned
to it.
One Page is Single page data
exceeds the
Too Large
configured mail size.
Operation Not You are in the Add
Page/Cancel Job
Assigned
operation, but there
are no jobs stored.
Out-Bin Full| The output tray of the
machine is full of
Open/Close Door
paper.
Paper Jam 0 Paper has jammed in
the feeding area of the
Open/Close Door
tray.
Paper has jammed
Paper Jam 1
inside the machine.
Open/Close Door
Special print media
Paper Jam 2
has jammed in the
Check Inside
paper exit area.
Refilled Toner The print cartridge you
have installed is not
genuine or refilled.
Replace Toner This message
appears between
Toner Empty and
Toner Low status.
Replace The life of the part
expires soon.
[xxx] Soon
Retry Redial? The machine is
waiting for a specified
time interval to redial
a previously busy
station.
Send Error There is a problem in
SMTP authentication.
(AUTH)
74 _Troubleshooting
SUGGESTED
SOLUTIONS
Delete unnecessary fax
jobs and retransmit after
more memory becomes
available. Alternatively,
split the transmission into
more than one operation.
Enter the number
manually using the
number keypad or store
the number or address.
Reduce the resolution and
try again.
Check the display to see if
there are any scheduled
jobs.
Remove paper. Open the
front cover and than close
it.
Clear the jam. See page
70.
Clear the jam. See page
71.
Clear the jam. See page
71.
The print quality may get
poor if the refilled print
cartridge is installed, since
its characteristics may
significantly differ from the
genuine.
We recommend Xerox-
genuine print cartridge.
Replace the print cartridge
with a new one. See page
65.
See page 66 and call for
service.
You can press OK to
immediately redial, or
Stop/Clear to cancel
the redial operation.
Configure the
authentication setting.
MESSAGE MEANING
Send Error There is a problem in
DNS.
(DNS)
Send Error There is a problem in
POP3.
(POP3)
Send Error There is a problem in
SMTP.
(SMTP)
Send Error There is a problem on
the network interface
(Wrong Config)
card.
Toner Empty The print cartridge has
run out. The machine
stops printing.
Press OK to toggle
the message to Stop
or Continue.
Stop
Toner Exhausted The lifespan of the
print cartridge which
the arrow indicates is
reached.
Toner Low The corresponding
print cartridge is
almost empty.
Updating Data This message
appears when there is
Please Wait...
a change in the
system setting or
when you back up a
data.
SUGGESTED
SOLUTIONS
Configure the DNS setting.
Configure the POP3
setting.
Change to the available
server.
Configure your network
interface card correctly.
You can select the option
among Stop or Continue
with the left/right arrow.
If you select Stop by
pressing OK on the control
panel, the machine stops
printing. If you select
Continue, the machine
keeps printing, but the
quality cannot be
guaranteed.
If you do not select any,
the machine will work as
Stop is selected.
Replace the print cartridge
with a new one. See page
65.
This message appears
when the toner is
completely empty, and
your machine stops
printing. Replace the
corresponding print
cartridge with a Xerox-
genuine cartridge. See
page 65.
Take out the print cartridge
and thoroughly shake it.
By doing this, you can
temporarily reestablish
printing operations.
Do not turn the power off
when this message is
showing. Changes may
not be saved and datas
can be lost.