Regulatory Information - Xerox WORKCENTRE 3210 User Manual

Regulatory Information

CE Mark
The CE mark applied to this product, symbolizes XEROX's
declaration of conformity with the following applicable European
Union Directives, as of the dates indicated:
December 12, 2006:
Council Directive 2006/95/EC as amended. Approximation of the
laws of the member states related to low voltage equipment.
December 15, 2004:
Council Directive 2004/108/EC as amended. Approximation of
the laws of the member states related to electromagnetic
compatibility.
March 9, 1999:
Council Directive 99/5/EC, on radio equipment and
telecommunications terminal equipment and the mutual
recognition of the conformity.
A full declaration of conformity, defining the relevant directives
and referenced standards, can be obtained from your XEROX
Limited representative.
WARNING:
In order to allow this equipment to
operate in proximity to Industrial Scientific and
Medical (ISM) equipment, the external radiation
from the ISM equipment may have to be limited or
special mitigation measures taken.
NOTE:
Changes or modifications to this equipment not
specifically approved by the Xerox Corporation may void the
user's authority to operate this equipment.
WARNING:
Shielded cables must be used with
this equipment to maintain compliance with
Council Directive 2004/108/EC.
12_Regulatory Information
EMC Information
FCC Notices For The USA
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications to this equipment not specifically
approved by the Xerox Corporation may void the user's authority
to operate this equipment.
EME Compliance for Canada
This Class "B" digital apparatus complies with Canadian ICES-
003.
Cet appareil numerique de la classe "B" est conforme a la norme
NMB-003 du Canada.
WARNING:
Shielded cables must be used with
this equipment to maintain compliance with FCC
regulations.