Getting Started; System Requirements; Windows - Xerox WORKCENTRE 3210 User Manual

getting started

This chapter gives you step-by-step instructions for setting up the machine.
This chapter includes:
• Setting up the hardware
•

System requirements

• Setting up the network
SETTING UP THE HARDWARE
This section shows the steps to set up the hardware which is explained in
the Quick Install Guide. Make sure you read Quick Install Guide and
complete following steps.
1. Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow
extra space to open covers and trays.
The area should be well-ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the machine close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the
altitude setting to optimize your printing. See "Altitude adjustment" on
page 29 for more information.
Place the machine on a flat, stable surface so that there is no incline
greater than 2 mm (0.08 inch). Otherwise, printing quality may be
affected.
2. Unpack the machine and check all the enclosed items.
• Installing the software
• Machine's basic settings
3. Remove the tape holding the machine tightly.
4. Install the print cartridge.
5. Load paper. (See "Loading paper" on page 37.)
6. Make sure that all the cables are connected to the machine.
7. Turn the machine on.
When you move the machine, do not tilt or turn it upside down.
Otherwise, the inside of the machine may be contaminated by toner,
which can cause damage to the machine or bad print quality.
SYSTEM REQUIREMENTS
Before you begin, ensure that your system meets the following
requirements:

Windows

Your machine supports the following Windows operating systems.
REQUIREMENT (RECOMMENDED)
OPERATING
SYSTEM
CPU
Windows Pentium II 400 MHz
(Pentium III 933 MHz)
2000
Windows XP Pentium III 933 MHz
(Pentium IV 1 GHz)
Windows Pentium III 933 MHz
(Pentium IV 1 GHz)
Server 2003
Windows Pentium IV 3 GHz
Vista
• Internet Explorer 5.0 or higher is the minimum requirement for all
Windows operating systems.
• Users who have an administrator right can install the software.
FREE HDD
RAM
SPACE
64 MB 600 MB
(128 MB)
128 MB 1.5 GB
(256 MB)
128 MB 1.25 GB to
(512 MB) 2 GB
512 MB 15 GB
(1024 MB)
Getting started_ 25