Exit Misfeed; Roller Misfeed; Clearing Paper Jams; In The Paper Feed Area - Xerox WORKCENTRE 3210 User Manual

Exit misfeed

1. Remove any remaining pages from the ADF.
2. Seize the misfeed paper, and remove the paper from the document
output tray by carefully pulling it to the right using both hands.
3. Load the removed pages back into the ADF.

Roller misfeed

1. Open the scanner lid.
2. Seize the misfeed paper, and remove the paper from the feed area by
carefully pulling it to the right using both hands.
3. Close the scanner lid. Then load the removed pages back into the ADF.
70 _Troubleshooting

CLEARING PAPER JAMS

When a paper jam occurs, the warning message appears on the display
screen. Refer to the table below to locate and clear the paper jam.
MESSAGE LOCATION OF JAM
Paper Jam 0 In the paper feed area or
inside the machine
Open/Close Door
Paper Jam 1 Inside the machine
Open/Close Door
Paper Jam 2 Inside the machine or in
the fuser area
Check Inside
Duplex Jam 0 Inside the machine
Check Inside
Duplex Jam 1 In the paper feed area or
inside the machine
Open/Close Door
Some messages may not appear in the display depending on options
or models.
To avoid tearing the paper, pull the jammed paper out gently and
slowly. Follow the instructions in the following sections to clear the
jam.

In the paper feed area

If paper is jammed in the paper feed area, follow the next steps to release
the jammed paper.
1. Pull the tray open.
2. Remove the jammed paper by gently pulling it straight out as shown
below.
If the paper does not move when you pull, or if you do not see the paper
in this area, check In the print cartridge area.
GO TO
Page 70, Page 71
Page 71
Page 71
Page 71
Page 71