Replacing The Print Cartridge - Xerox WORKCENTRE 3210 User Manual

REPLACING THE PRINT CARTRIDGE

When the print cartridge is completely empty, you must replace the print
cartridge.
• The status LED and the toner-related message on the display indicates
that the print cartridge should be replaced.
• Incoming faxes are saved in memory.
At this stage, the print cartridge needs to be replaced. Check the type of
print cartridge for your machine. (See "Ordering supplies and
accessories" on page 83.)
1. Turn the machine off, then wait a few minutes for the machine to cool.
2. Completely open the front cover.
• Do not touch the green surface, the OPC drum or the front of
each print cartridge, with your hands or any other material. Use
the handle on each cartridge in order to avoid touching this area.
• Be careful not to scratch the surface of the paper transfer belt.
• If you leave the front cover open for more than a few minutes, the
OPC drum can be exposed to light. This will cause damage to the
OPC drum. Close the front cover should the installation need to
be halted for any reason.
3. Grasp the handles on the print cartridge and pull to remove the cartridge
from the machine.
4. Take a new print cartridge out of its package.
• Don't use sharp objects, such as a knife or scissors, to open
the print cartridge package. You could damage the surface of
the print cartridge.
• To prevent damage, do not expose the print cartridge to light
for more than a few minutes. Cover it with a piece of paper to
protect it if necessary.
5. Holding both handles on the print cartridge, thoroughly rock it from side
to side to evenly distribute the toner.
6. Place the print cartridge on a flat surface, as shown, and remove the
paper covering the print cartridge by removing the tape.
If toner gets on your clothing, wipe it off with a dry cloth and wash
it in cold water. Hot water sets toner into fabric.
7. Grasp the handles on the print cartridge. Insert the cartridge until it clicks
into place.
8. Close the front cover. Make sure the cover is securely latched, and then
turn the machine on.
If the front cover is not completely closed, the machine will not
operate.
Maintenance_ 65