Adjusting The Output Support; Stacking Papers Firmly; Setting The Paper Size And Type - Xerox WORKCENTRE 3210 User Manual

Place the side to be printed facing up.
Preprinted paper
Envelope
Card stock
Punched paper
Label
3. When you print in application, start the print menu.
4. Before you print, open printer properties.
5. Press the Paper tab in printer properties, and select an appropriate
paper type.
If you want to use a label, set the paper type to Label.
6. Select Manual Feeder in paper source then, press OK.
7. Start printing in application.
• If you are printing multiple pages, load the next sheet after first
page prints out. Repeat this step for every page to be printed.
• The settings you change remain in effect only while you are
using the current application.
• If envelopes are printed out with wrinkles, crease or black bold
lines, open the rear cover and pull down the pressure lever on
the right side about 90 degrees and try printing again. Keep the
rear cover opened during printing.
Pressure lever
38 _Loading originals and print media

ADJUSTING THE OUTPUT SUPPORT

The printed pages stack on the output tray, and the output support will help
the printed pages align. To let the output support correctly align the pages
you need to pull it out appropriately depending on the paper size.
Transparency
Letterhead paper

Stacking papers firmly

If you use a machine in a humid area, or you are using the damp print media
caused by a high humidity, the print-outs on the output tray may be curled
and may not be stacked properly. In this case, you can set the machine to
use the Paper Stacking function to let print-outs stacked firmly. But, using
this function will make the print speed slow.
1. Press Menu
2. Press the left/right arrow until Maintenance appears and press OK.
3. Press the left/right arrow until Paper Stacking appears and press OK.
4. Press the left/right arrow to select On or Off and press OK.
5. Press Stop/Clear

SETTING THE PAPER SIZE AND TYPE

After loading paper in the paper tray, you need to set the paper size and
type using the control panel buttons. These settings will apply to Copy and
Fax modes. For PC-printing, you need to select the paper size and type in
the application program you use on your PC.
1. Press Menu
2. Press the left/right arrow until Paper Setup appears and press OK.
3. Press OK when Paper Size appears.
4. Press the left/right arrow until the paper tray you want appears and
5. Press the left/right arrow until the paper size you are using appears and
6. Press the left/right arrow until Paper Type appears and press OK.
7. Press the left/right arrow until the paper tray you want appears and
8. Press the left/right arrow until the paper type you are using appears and
9. Press Stop/Clear
• If the output support is incorrectly adjusted, printed pages may be
mis-aligned or fall.
• If you continuously print many pages, the surface of the output tray
may become hot. Be careful not to touch the surface, and
especially keep children away from the surface.
until System Setup appears on the bottom line of the
display and press OK.
to return to ready mode.
until System Setup appears on the bottom line of the
display and press OK.
press OK.
press OK.
press OK.
press OK.
to return to ready mode.
1 Output support