Installing Software For Network Printing - Xerox WORKCENTRE 3210 User Manual

N
: If your printer is not already connected to the computer, the
OTE
following window will appear.
• After connecting the printer, click Next.
• If you don't want to connect the printer at this time, click Next, and No
on the following screen. Then the installation will start and a test page
will not be printed at the end of the installation.
• The installation window that appears in this User's Guide may
differ depending on the printer and interface in use.
6
Select the components to be installed and click Next.
N
: You can change the desired installation folder by clicking
OTE
[Browse].
7
After the installation is finished, a window asking you to print a test
page appears. If you choose to print a test page, select the
checkbox and click Next.
Otherwise, just click Next and skip to step 9.
8
If the test page prints out correctly, click Yes.
If not, click No to reprint it.
9
Click Finish.
6
Installing Printer Software in Windows

Installing Software for Network Printing

When you connect your printer to a network, you must first configure the
TCP/IP settings for the printer. After you have assigned and verified the
TCP/IP settings, you are ready to install the software on each computer
on the network.
You can install the printer software using the typical or custom method.
Typical Installation
This is recommended for most users. All components necessary for
printer operations will be installed.
1
Make sure that the printer is connected to your network and
powered on. For details about connecting to the network, see the
supplied printer's User's Guide.
2
Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run, and an installation window
appears.
If the installation window does not appear, click Start and then
Run. Type X:\Setup.exe, replacing "X" with the letter which
represents your drive and click OK.
If you use Windows Vista, click Start → All programs →
Accessories → Run, and type X:\Setup.exe.
If the AutoPlay window appears in Windows Vista, click Run
Setup.exe in Install or run program field, and click Continue in
the User Account Control window.
3
Click Install Software.