802.1X Authentication - Xerox 5222 System Administration Manual

14 Authentication and Account Administration
6.
A dialog box will prompt you to specify the name and location for the cloned file.
Ensure the extension reads .dat .
7.
Click [Save]. The .dat file can now be used to restore the information to the same
machine or to clone other machines.
To Restore Settings or Clone Settings to another Machine
NOTE: This procedure will cause the machine to reboot and be inaccessible over the
network for several minutes.
1.
Open your web browser and enter the TCP/IP address of the machine you wish to
restore or clone the settings to. Press <Enter>.
2.
Click the [Properties] tab.
3.
Expand the [General Setup] folder.
4.
Select [Cloning].
5.
In the [Install Clone File] portion of the displayed dialog, click [Browse].
6.
Locate the .dat clone file.
7.
Click [Install].
NOTE: It may be necessary for you to use your web browser to view the Xerox
Standard Accounting set up of Users and Groups on the new machine.

802.1x Authentication

The machine supports 802.1x authentication based on the Extensible Application
Protocol (EAP). 802.1x can be enabled for devices connected through both wired and
wireless Ethernet networks. As described here, the 802.1x configuration is used to
authenticate the machine, rather than individual users. After the machine has been
authenticated, it will be accessible to users on the network.
The System Administrator can configure the machine to use one EAP type. EAP types
currently supported on the machine are: EAP-MD5, EAP-MS-CHAPv2, and PEAP/MS-
CHAPv2.
Before you configure 802.1x authentication, the following configuration is required.
• Create a user name and password on your authentication server which will be used
to authenticate the machine.
• Ensure your 802.1x authentication server and authentication switch are available on
the network.
Configuring 802.1x with CentreWare Internet Services
Use the following procedure to configure 802.1x with CentreWare Internet Services.
NOTE: 802.1x can be configured also on the control panel of the machine. For details,
refer to
1.
In CentreWare Internet Services, click the [Properties] tab.
2.
Expand the [Security] folder.
3.
Select [802.1x] in the directory tree.
4.
Select the [Enabled] check box for [Enable IEEE 802.1x].
5.
From [Authentication Method], select the required authentication method.
330
IEEE 802.1x Settings on page 99
.