Local Machine Authentication Setup - Xerox 5222 System Administration Manual

6.
In [Login Name: (Device Name)], [Password], and [Retype Password], enter the
user name and password required by your authentication switch and server.
7.
If you selected [PEAP/MS-CHAPv2] in step 5, set whether or not to validate the
server certificate under [Certificate Validation].
8.
Click [Apply].
9.
If prompted, enter the System Administrator user ID and passcode.
NOTE: The default System Administrator user ID and passocde are "11111" and "x-
admin" respectively.

Local Machine Authentication Setup

When [Login to Local Accounts] is enabled, the System Administrator can define
passcodes for authorized users (and guests, when the selection is available) to use to
authenticate to the system and access restricted services.
Preparations:
1.
Ensure the machine is fully functional on the network.
2.
Ensure that the TCP/IP and HTTP protocols are configured on the machine and
fully functional. Refer to those topics in this guide for configuring information as
required. This is required to access CentreWare Internet Services to configure
authentication. The Internet Services function is accessed through the embedded
HTTP server on the machine and allows System Administrators to configure
Authentication settings by using an Internet browser.
At Your Workstation:
1.
Open your web browser and enter the TCP/IP address of the machine in the
[Address] or [Location] field. Click [Enter] to access CentreWare Internet Services.
2.
Click the [Properties] tab.
3.
Expand the [Accounting] folder, and then click [Accounting Configuration]. On the
page displayed, select [Local Accounting] from the [Accounting Type] drop-down
list.
4.
Click [Apply] to reboot the machine.
5.
Expand the [Security] folder, and then click [Authentication Configuration]. On the
page displayed, select [Login to Local Accounts] from the [Login Type] drop-down
list.
6.
Click [Apply] to reboot the machine.
7.
Expand the [Security] folder, and then click [Authentication Configuration]. On the
page displayed, place a check mark in the [Enabled] box for each service that you
wish to restrict access to.
8.
Click [Next].
9.
To configure authentication for each account user, enter an account number in the
[Account Number] box and click [Edit].
10.
Fill in the settings for the user.
NOTE: Set [Feature Access] as required. DO NOT set a service to "No Access",
unless you wish to deny user access to that specific service.
Local Machine Authentication Setup
331