Unix Tcp/Ip; Information Checklist - Xerox 5222 System Administration Manual

8 Printer Environment Settings
5.
Repeat the test for all computers that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to

UNIX TCP/IP

This section explains how to set up the machine to operate in a UNIX TCP/IP
environment. The UNIX Workstation Operating Systems (OS) supported are Solaris,
SunOS, and HP-UX. The following information is provided:
Information Checklist – page 232
UNIX TCP/IP Environments – page 233
UNIX TCP/IP Installation – page 233
Installation Procedure – page 233
Network Communication Setup – page 233
Workstation Setup – page 235
Test Print – page 239
Printing – page 240
Solaris/HP-UX – page 240
SunOS – page 241
Printer Status – page 243
Solaris/HP-UX – page 243
SunOS – page 244
-C Option – page 245

Information Checklist

Before installing the UNIX TCP/IP features on the machine, make sure that the
following items are available or have been performed.
An existing operational network utilizing a UNIX TCP/IP protocol is
required. These steps are not designed to install the UNIX TCP/IP
network.
SunOS 4.1x, Solaris 1.x, 2.x, 7.x, 8.x, 9.x, 10.x, HP-UX 9.x, 10.x, 11.x
Make sure that the correct IP Address is being used for the machine.
Make sure that the Gateway Address is set correctly.
Make sure that the Subnet Mask (for IPv4) or Prefix (for IPv6) is set
correctly.
Make sure that the Host Name is set correctly.
Test the machine to make sure that it is fully installed and functioning
correctly.
If you encounter problems during the installation of the machine, refer to
Solving chapter on page 341.
232
Problem Solving chapter on page 341.
Item By
Customer
Customer
Customer
Customer
Customer
Customer
Customer
Problem