Xerox 5222 System Administration Manual page 418

15 Problem Solving
Code
116-220
116-392
116-701
116-702
116-703
116-713
116-720
116-740
116-749
116-752
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
116-780
116-790
123-400
124-328
124-701
124-702
124-705
418
The machine failed to move onto the Download mode. Contact the Xerox
Welcome Center.
The Printer or PostScript kit is attached to an improper slot on the controller
board. Attach the Printer or PostScript kit to the correct slot.
Unable to print double-sided due to insufficient memory. Check if memory is
installed correctly. If the problem persists, contact the Xerox Welcome Center.
Data was printed using a substitute font. Check the print data.
An error occurred during PostScript processing. Check the print data, or disable
bi-directional communication on the print driver.
The data was divided because the hard disk ran out of space. Delete
unnecessary data from the hard disk.
A print error occurred due to insufficient memory. Close unused ports or delete
unnecessary data.
A print error occurred. A parameter value is greater than the limit value. Check
the print settings.
The print job was stopped, because the specified font was not found. Install the
font, or enable the font substitution setting in the print driver.
The description in the PDF print job ticket has a problem. Repeat the same
procedure. Contact the Xerox Welcome Center if the problem persists.
The parameter values were corrected, because the machine encountered a
problem when printing the data. If the received image is incomplete or
damaged, ask the sender to check the image and to resend the data. When
Internet Fax forwarding is enabled, check with the recipient if the image has no
problem.
The document attached to the received e-mail has a problem. Check the
attached document.
• If the machine did not staple any print sets, check that the specified stapling
position is appropriate, and then try again.
• If a user stops a confidential Fax or Internet Fax print job while the machine is
printing the data of the job, the machine will not staple the first print set.
Manually staple the first set in that case.
The machine has detected a software-related problem. Switch off the machine,
and then switch it on again. Contact the Xerox Welcome Center if the problem
persists.
A punch unit was not found. Specify a punch unit following the screen
instructions.
Due to a malfunction in the specified tray (left side tray), the output destination
was changed to the center tray. Contact the Xerox Welcome Center. The other
trays are available.
Due to a malfunction in the specified tray (finisher tray), the output destination
was changed to the center tray. Contact the Xerox Welcome Center. The other
trays are available.
The punch setting was cancelled.
Check the punch position, and try again.
Description and Remedy