Control Of Media Heating System During Preheating; Drying The Trailing Edge Of The Printing Area On The Dryer - Roland VersaArt RE-640 User Manual

Default Setting
ECO-SOL MAX ink model
[PRINT] : 35 °C (94 °F)
[DRYER] : 40 °C (104 °F)
Water-based pigment ink model
[PRINT] : OFF
[DRYER] : OFF

Control of Media Heating System during Preheating

Note: Preheating: State that the main power and the sub power are switched on and
(state that media setup is not completed)
Procedure

Press .

MENU
HEATER MENU

HEATER MENU
PREHEATING

PREHEATING
30 C MENU

W1200mm
SETUP SHEET
Default Setting
ECO-SOL MAX ink model
[PREHEATING]: 30 °C (86 °F)
Water-based pigment ink model
[PREHEATING]: OFF

Drying the Trailing Edge of the Printing Area on the Dryer

Procedure

Press .
Fully Utilize the Media Heating System
Press several times to display the left figure.
Press , and then
Press .
Press
MENU: The system performs heating to the preset tem-
perature at all times, without lowering the temperature
during preheating.
30 °C: The system keeps 30 °C during preheating.
OFF: The system switches the media heating system off
during preheating.
Press
to enable the setting.
Press to go back to the original screen.
is not lighted
.
to select setting.
4
89