Throttle Cable - Stihl MS 441 Manual

Correcting the carburetor setting
for operation at high altitude
A minor correction may be
necessary if engine performance is
not satisfactory.
– Check standard setting.
– Let engine warm up.
– Turn high speed screw H
clockwise (leaner), but no further
than the stop.
If the setting is made too lean, the
engine may be damaged due to
insufficient lubrication and
overheating.
If these adjustments do not yield
any improvement, refer also to the
troubleshooting chart for ignition
system, carburetor and engine,
b 4.5, b 4.6 and b 4.7.
MS 441, MS 441 C
14.6

Throttle cable

2
1
– Remove carburetor, b 14.3.
– Remove anti-vibration spring on
fuel tank, b 11.3.
: Disconnect throttle cable (1) from
lever (2).
1
: Pull throttle cable (1) out of guide
(arrow).
1
: Pull throttle cable (1) out of
carburetor housing.
– Examine throttle cable and
replace if necessary.
2
1
: Slide throttle cable (1) through
grommet (2) with the double-
nipple (arrow) first.
2
1
– Examine throttle cable retainer,
replace if necessary, b 7.3.2.
: Connect throttle cable (1) to
lever (2) and guide wire through
slot (arrow).
1
2
: Push throttle cable grommet (1)
into guide (arrow) of throttle cable
retainer (2).
113