Stihl MS 441 Manual page 89

3
– Examine throttle trigger (1),
lever (2) and leg spring (3),
replace if necessary.
1
: Hook leg spring (1) into throttle
trigger (2), noting the installed
position (arrow).
: Push lever (1) into place.
– Turn throttle trigger with lever
over.
88
2
1
: Push throttle cable (1) into hole
(arrow) until the wire (2) engages
the guide of the lever (3).
2
: Fit throttle trigger (1) with lever
(2) so that the leg spring is
located in the guide (arrow).
1
2 1
1
2
1
: Centre the throttle trigger (1) with
punch (2).
– Drive in the pin until it is
equidistant on both sides.
1
: Centre lever (1) with punch (2).
– Drive in the pin until it is
equidistant on both sides.
– Check correct operation.
– Grease roller (arrow) before
installing it, b 17.
MS 441, MS 441 C
2
2