Stihl MS 441 Manual page 83

: Lift front handle (1) slightly at the
side and remove it from the guide
(arrow).
: Slide front handle (1) out of lower
guide and turn it towards the
spiked bumper.
– Remove front handle.
: First lift stop (1) out of bottom
mount (arrow) and then pull it up
and off.
82
2
1
1
: Pull handle inlays (1) out of front
handle (2).
– Examine handle inlays, front
handle and stop, replace if
necessary.
– Slide handle inlays (1) back into
front handle.
1
1
: First push stop (1) into the upper
ridge (arrow), then press it into
the lower mount.
1
1
: First position front handle (1)
against the bottom handle mount
(arrow), then turn it towards the
rear handle.
: Lift front handle (1) slightly at the
side and ease it into the guide
(arrow).
– Ensure that the stop is correctly
positioned.
– Fit and tighten screws.
– Reassemble all other parts in the
reverse sequence.
Tightening torques, b 3.5.
1
MS 441, MS 441 C
1