Throttle Trigger / Interlock Lever - Stihl MS 650 Manual

Hide thumbs Also See for MS 650:
Table of Contents

Advertisement

2
2
1
Installing
: Fit the switch shaft (1) in the
"STOP" position, the contact
spring (arrow) on top.
: Push the switch shaft into the
mounts (2) on the housing.
: Engine the retainer (1).
66
: Attach the throttle rod (1) to the
throttle trigger.
– Fit the handle molding.
– Connect short circuit wire to
switch shaft.
– Install the carburetor – b 12.2.1
– Check operation.
Reassemble all other parts in the
reverse sequence.
1
1
10.2
Throttle Trigger /
Interlock Lever
2
– Remove the air filter – b 12.1
: Take out the screw (1).
: Remove the handle molding (2).
1
2
: Pull the throttle rod (1) sideways
out of the trigger (2).
– Move the Master Control to the
"RUN" position.
: Remove the interlock lever (1).
MS 650, MS 660
1
1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ms 660

Table of Contents