Front Handle With Handle Heating - Stihl MS 441 Manual

11.5.1 Front handle with handle
heating
As the front handle is heated in
these machines, the wiring must
also be disconnected for
installation.
– Troubleshooting, b 15.3.1.
Except for the electrical
connections, removal and
installation of the front handle is the
same as for the front handle without
heating, b 11.5.
– Unscrew carburetor housing and
lift it up, b 14.6.2.
: Pull plug connections (arrows)
out of guides.
– Pull wiring out of cable guides.
– Slide insulating tubes (1) towards
the front handle.
: Disconnect plug connections
(arrows).
MS 441, MS 441 C
: Pull out leads (arrows) between
stop (1) and housing.
– Remove front handle, b 11.5.1.
2
1
: Pull handle inlays (1) out of front
handle (2).
– Examine handle inlays, front
handle and stop, replace if
necessary.
1
1
1
– Test handle heating,
b 15.3.1.
– Install front handle, b 11.5.1.
: Fit leads (arrows) between
stop (1) and housing.
1
– Securely reconnect plugs and
terminal sockets (arrows).
: Slide insulating tubes (1) back
over the plug connections.
1
1
1
83