The new brake cable is supplied
with preassembled throttle cable
retainer.
The throttle cable retainer must be
removed from the brake cable if
only the retainer is to be replaced.
1
2
: Undo clamping screw (arrow)
and take out adjusting screw (1).
– Pull out brake cable (2) and
replace throttle cable retainer.
1
: Slide long hook (1) of brake cable
through hole (arrow) and turn
adjusting screw (2) down as far
as possible.
32
– Tighten clamping screw.
: Slide short hook (1) of brake
cable through hole (arrow).
: Pull brake cable (1) through
opening in housing and attach it
to hole (arrow) in brake lever.
2
: Push grommet of brake cable (1)
as far as possible into opening in
housing (arrow).
1
2
: Slide lug of throttle cable
– Fit and tighten the screw.
1
: Insert brake cable (1) in guide
– Install switch lever, b 12.3.1.
1
: Push end of throttle cable (1) with
– Install throttle trigger and handle
retainer (1) into mount (arrow)
and press it into the mount (2).
1
(arrow).
1
round nipple through guide
(arrow) as far as possible.
moulding, b 12.3.
MS 441, MS 441 C
1