Condition
Engine will not idle, idle speed too
high
Engine stalls at idle speed
16
Cause
Throttle shutter opened too wide by
idle speed screw LA
Oil seals / crankcase leaking
Air flap dirty – air flap does not
close
Air flap stiff
Throttle cable stiff – throttle shutter
does not close
Idle jet bores or ports blocked
Idle jet too rich or too lean
Setting of the idle speed screw
incorrect – throttle shutter
completely closed
Remedy
Correct setting of idle speed
screw LA
Seal or replace oil seals /
crankcase
Clean air flap, install new
carburetor if necessary
Check carburetor, replace if
necessary
Fit new throttle cable
Clean the carburetor
Set low speed screw L correctly
Set idle speed screw LA correctly
MS 441, MS 441 C