Wiring Harness; Removal - Stihl MS 441 Manual

Hide thumbs Also See for MS 441:
Table of Contents

Advertisement

15.8

Wiring harness

15.8.1 Removal

– Remove shroud, b 8.4.
– Pull boot off spark plug, b 9.4.
– Remove ignition module,
b 9.1.1.
Remove flywheel, b 9.5, so that
generator lead can be routed
correctly.
– Remove carburetor support,
b 14.6.1.
– Remove short circuit wire,
b 9.6.2.
: Pull wiring harness (1) and plug
connection out of cable guides
(arrows).
1
: Slide insulating tube (1) towards
generator lead and disconnect
plug connection.
MS 441, MS 441 C
1
: Pull grommet (1) off wiring
harness (2).
– Examine grommet for signs of
damage, replace if necessary.
1
1
: Pull plug connection (1) and
wiring out of guides (arrows).
1
: Slide insulating tube (1) towards
carburetor heating element and
disconnect plug connection.
– Pull wiring harness out through
opening at the side (arrow).
2
: Pull cable retainer (1) off.
: Pull contact sleeve (1) out of
heating switch.
: Pull wiring harness out of cable
guides (arrows).
: Prise out grommet (1) and pull it
off the wiring harness.
– Examine grommet, replace if
necessary.
1
1
1
137

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents