Cam Lever - Stihl MS 441 Manual

– Check correct operation and
adjust brake cable if necessary,
b 7.3.1.
2
: Guide fuel hose (1) under brake
cable (2) and push it onto
connector (arrow).
– Install carburetor housing,
b 14.6.2.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5.
MS 441, MS 441 C
7.4

Cam lever

The cam lever defines the engaged
position of the hand guard. The
hand guard cannot be engaged in
the position "Release or apply
brake" if the spring or cam on the
cam lever or hand guard is
defective.
– Remove brake lever, b 7.2.
QuickStop Super, b 7.3.
1
: Unhook spring (1) from anchor
pin (arrow).
1
: Take out circlip (arrow).
– Remove cam lever (1) from pivot
pin.
– Examine cam lever (1) and
spring (2) and fit new parts if
necessary.
– Check condition of cam guide
(arrow) and replace hand guard if
necessary.
1
1
– Position cam lever (1) so that
cam (arrow) points towards
throttle trigger.
: Slide cam lever onto pivot pin (2).
1
: Fit circlip (1).
2
1
2
33