Brake Lever - Stihl MS 441 Manual

: First place brake band in guide
(arrow).
1
: Then guide brake band (1) over
studs (arrows) and press it into
the mount.
1
2
: Press brake band (1) into guide
(arrow) and at the same time
guide it over the studs (2).
MS 441, MS 441 C
1
: Fit and tighten down screw (1).
– Tightening torques, b 3.5.
– Reassemble all other parts in the
reverse sequence.
– Check correct operation.
7.2

Brake lever

1
– Troubleshooting chart, b 4.2.
– Remove shroud, b 8.4.
– Remove brake band, b 7.1.
– Push hand guard towards saw
chain.
The brake spring is now relaxed.
: Ease brake spring (1) off pivot pin
(arrow).
– Disconnect brake spring from
brake lever.
: Take out screw (arrow).
25