Stihl MS 441 Manual page 143

No. Part name
20 Locking strip for assembly stand
21 Ignition system tester ZAT 4
22 Ignition system tester ZAT 3
23 Torque wrench
24 Torque wrench
25 Assembly tool 12
26 Screwdriver
- Setting washer
27 Screwdriver bit T 27 x 150
28 Assembly hook
29 Assembly stand
30 Puller
- Claws (with profile No. 3.1)
31 Puller
32 Crimping pliers
33 Stud puller M8
34 Screw sleeve
35 Socket, 13 mm, long
36 Assembly hook
Remark:
1) Only to be used for releasing.
142
Part No. Use
5910 850 1650 Clamping machine on assembly stand
5910 850 4503 Testing ignition system
5910 850 4520 Testing ignition system
5910 890 0302 Screw connections (0.5 to 18 Nm)
5910 890 0312 Screw connections (6 to 80 Nm)
5910 890 2212 Fitting hookless snap rings in piston
5910 890 2304 Carburetor adjustment
5910 893 6600 Supplement to screwdriver
(carburetor adjustment)
5910 890 2400 IS-P screws (4 mm)
5910 890 2800 Disconnecting helical springs from
clutch shoes
5910 890 3100 Mounting chainsaw for repairs
5910 890 4400 Pulling out oil seals
0000 893 3706 Pulling out oil seal(s)
5910 890 4500 Pulling off limiter caps
5910 890 8210 Cable ties, cable lugs, etc.
5910 893 0501 Unscrewing bar mounting studs
5910 893 2420 Pulling in crankshaft
5910 893 2804 Removal and installation
of decompression valve
5910 893 8800 Pulling out pick-up body
Remarks
MS 441, MS 441 C