Carburetor Housing - Stihl MS 441 Manual

– Use STIHL Press Fluid for easier
insertion, b 17.
: Pull elbow flanges through the
openings in the carburetor
support with the aid of the string.
The rubber lips must enclose the
openings completely.
1
1
: Press sleeves (1) into the
openings of the elbow and fit
washer (2).
116
2
3
4
– Guide throttle cable between fuel
hose and impulse hose.
: Press throttle cable (1) into guide,
so that wire glides through
felt (2).
: Press impulse hose (3) and fuel
hose (4) into the mounts
(arrows).
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5.
2

14.6.2 Carburetor housing

– Remove pre-separator, b 9.7.
1
– Remove shroud, b 8.4.
– Remove short circuit wire,
b 9.6.2.
– Remove carburetor support,
b 14.6.1.
– Remove intake elbow,
b 14.6.3.
– Remove anti-vibration spring on
front handle, b 11.2.
Machines with handle heating
– Remove wiring harness,
b 15.8.1.
– Remove heating switch,
b 15.4.
: Pull off grommet (1) and examine
it, replace if necessary.
– Use STIHL Press Fluid for easier
insertion, b 17.
1
MS 441, MS 441 C