Throttle Control; Throttle Trigger Interlock, Throttle Trigger - Stihl TS 400 Manual

STIHL TS 400
9.

THROTTLE CONTROL

9.1

Throttle trigger interlock, throttle trigger

- Remove cap from shroud,
see 6.5.
• Unscrew screw (1) in handle
moulding (2).
- Move slide control forwards to
"0" (STOP).
- Draw handle moulding back
slightly and remove it.
• Remove throttle trigger interlock
from bearing.
• Remove slide control from
bearing.
• Prise throttle rod (1) out of
throttle trigger (2).
• Drive out straight pin (1) with a
drift, dia. 4 mm.
• Remove throttle trigger (2) with
torsion spring (3).
• Remove torsion spring from
throttle trigger.
The parts are installed in reverse
order.
Note: The leaf spring (1) must be
located in front of the slide control
and the stop rod (2) below it.
Set the slide control to "I".
Press throttle trigger interlock
downwards.
Slide handle moulding up so that the
tabs rest in the mounts (1).
37