Stihl MS 441 Manual page 111

H
1
: Turn limiter cap until lug (2) is
lined up with groove (1).
The dot on the limiter cap must be
lined up with the mark (arrow).
1
: Pull off limiter cap (1).
– Unscrew low speed screw L.
: Examine tip (arrow) for signs of
damage or wear, replace low
speed screw L if necessary.
110
– Turn in low speed screw L until it
is fully in its seat.
– Continue with high speed screw.
L
2
High speed screw
: Screw puller (1) 5910 890 4500
onto limiter cap – left-hand
thread.
H
2
: Turn limiter cap until lug (2) is
lined up with groove (1).
The dot on the limiter cap must be
lined up with the mark (arrow).
: Pull off limiter cap (1).
– Unscrew high speed screw H.
1
: Examine tip (arrow) for signs of
– Turn in high speed screw H until
– Continue with Fitting the limiter
L
1
1
damage or wear, replace high
speed screw H if necessary.
it is fully in its seat.
caps.
MS 441, MS 441 C