Stihl MS 441 Manual page 87

2
: Pull out the lever (1).
: Unhook leg spring (2) from
throttle trigger.
3 4
– Examine throttle trigger (1),
lever (2), trigger interlock (3) and
leg spring (4), replace if
necessary.
2
1
: Hook leg spring (1) into throttle
trigger (2), noting the installed
position (arrow).
86
1
: Push lever (1) into place.
– Turn throttle trigger with lever
over.
2
1
: Push throttle cable (1) into hole
until the wire engages the guide
(arrow) of the lever (2).
Machines with handle heating
Ensure that the wiring is located in
the guides (arrows).
1
2 1
1
2
: Centre the throttle trigger (1) with
punch (2).
– Drive in the pin until it is
equidistant on both sides.
: Centre lever (1) with punch (2).
– Drive in the pin until it is
equidistant on both sides.
: When installing the trigger
interlock, ensure that the stop (1)
engages the guide (arrow).
MS 441, MS 441 C
1
2
1