Stihl MS 441 Manual page 63

: Use suitable pliers to pull leg
spring out of spark plug boot.
– Unhook leg spring from ignition
lead.
– Pull boot off ignition lead.
– Cut new ignition lead to the
specified length.
– Use a pointed tool to pierce the
centre of the new ignition lead's
insulation about 15 mm from the
end of the lead.
: Pinch the hook of the leg spring
into the centre of the lead (arrow).
62
– Coat the inside of the spark plug
boot with STIHL Press Fluid,
b 17.
: Hold ignition lead together with
leg spring and push them into the
spark plug boot.
: Make sure that the leg spring is
properly located in the spark plug
boot (arrow).
– Slide cover back over spark plug
boot.
: Pierce the end of the ignition lead
to be screwed into the ignition
module with a pointed tool.
– Slide grommet into place.
Do not use either graphite grease or
silicone insulating paste.
– Install ignition module and adjust
clearance between ignition
module and flywheel, b 9.1.
– Reassemble all other parts in the
reverse sequence.
MS 441, MS 441 C