Anti-Vibration Spring, Oil Tank; Stop Buffers - Stihl MS 441 Manual

11.3.1 Anti-vibration spring,
oil tank
– Remove chain catcher, b 6.
: Take out screws (arrows).
– Prise off anti-vibration spring (1).
1
– Examine anti-vibration spring,
replace if necessary.
: Ensure that spring (1) is fully
screwed into the bearing plugs
(arrows).
: Position anti-vibration spring (1)
so that the form of the bearing
plug (2) engages the mount in the
crankcase (arrow).
80
1
– Press anti-vibration spring (1)
into bearing seat in tank housing.
: Fit screws (arrows) and tighten
them down.
– Tightening torques, b 3.5.
– Reassemble all other parts in the
reverse sequence.
2
1
11.4

Stop buffers

The stop buffers are located
between tank housing and
crankcase and are installed on the
ignition and clutch sides.
Stop buffer on clutch side
1
– Remove chain sprocket cover,
bar and chain, b 5.
1
: Prise out stop buffer (1).
– Examine stop buffer and replace
if necessary.
3
2
– Position stop buffer (1) with
the tapered side facing the
crankcase.
MS 441, MS 441 C
1