Stihl MS 441 Manual page 116

1
: Remove washers (arrows) and
pull out felt (1).
– Examine carburetor support and
all attached parts, replace if
necessary.
1
– Slide washers onto stud bolts.
: Slide preheating plate (1) onto
stud bolts so that it engages the
air duct (arrow).
: Fit air guide inlet (1) until it
engages the heel (arrow).
MS 441, MS 441 C
1
: Fit air guide outlet (1) until it
engages the heel (arrow). Peg (2)
must engage the notch.
1
– Install contact spring b 9.6.2.
: Slide felt (1) into mount.
– Examine impulse hose, replace
if necessary, b 14.6.4.
– Examine fuel hose, replace if
necessary, b 14.8.2.
1
– Examine throttle cable, replace
if necessary, b 14.6.
– Examine intake elbow, replace
if necessary, b 14.6.3.
2
: Tie a piece of string round each
flange (arrows), forming a loop
with a simple knot and gently
pulling it tight.
1
: Guide the ends of the string
through the openings (arrows) in
the carburetor support (1).
– Fit carburetor support against
intake elbow and slip ground wire
connector onto contact spring.
115